Features & Options
Horizontal parking on upper and lower level.
The Liftparker emphasizes conveniences.
Scope of supply / Options
Features of the Liftparker N 4100 comfort E/D
- Key switch incl. emergency stop, dead man's
control type with brief operating instructions and wiring
to aggregate
- "Lockable key switch" -Key is extractable
from switch only when the installation is lifted.
- s/d-installation with 2 platforms, 2 column assemblies
c/w hydraulic cylinder, lifting carriage
- Width of lot 230cm and depth of pit 170/165 cm as
standard
- Width of lot modified to 240cm and wider or
- PD 185/180 and deeper recommended for higher car accessibility
and conveniences synchronizing device to improve operation
with unequal load distribution entering wedge for car
positioning.
- Safety device to prevent from lowering in case of
pipe fracture
- Mounting on installation and aggregate with HD-anchors,
wiring with impact dowels
- Bounded anchors for increased foundation requirements
- Drive unit "Silencio" with tubing and wiring
to the installation
- Hydraulic package "parallel operation":
Simultaneous lifting of 2 or more installations per
aggregate at given pump capacity, or simultaneous lowering
respectively
- Structure-borne noise package to comply with DIN 4109
and adherence to
- sound insulation measure Rw '55
- Sound insulation hood to minimize airborne sound
- HVLP-oil for excessive fluctuations in temperature
- Drive plates in trapezoid style sheeting
- Rubber profiles in the pedestrian area, width 40cm
or 60cm, in the pedestrian and drive area 60cm and 40cm
- Luxury sheet metal only for horizontal lots
- Corrosive prevention "Classic" of drive
plates by continuous line-galvanizing to DIN EN 10142/10143
- Corrosion prevention "Premium" of drive
plates by individual piece-galvanizing to DIN ISO 1461
- Corrosion prevention "Classic Plus" of drive
plates by line-galvanizing to DIN EN 10142/10143 and
coating of the top surfaces
- Corrosion prevention "Premium Plus" of the
driving plates by individual piece-galvanizing to DIN
ISO 1461 and coating of the top surfaces
- Railings to avoid risk of falling onto the platform,
insofar as necessary
- (Note: Safe guarding against shearing and squeezing
have priority and must be provided by the proprietor)
- Ramps when door facing is not available to install
the door slide rail, pit length must be 525cm, at the
minimum
- Vehicle load: 2,0 to, length: 5m, as per vehicle data
- Extra capacity of upper platform to 2,5 to, vehicle
length up to 5,20m
- A maintenance contract is recommended
- Attendance and cleaning to requirements or at regular
intervals is recommended
Intersections/Customer's Duties
- Lockable main switch, near to aggregate, completed
at the beginning of erection
- Capacity of the aggregate: 400volt, 50Hz, three phrase
motor 3,0kw
- Supply line to main switch 5 x 1,5mm2 or to local
regulations, fuse protection 3 x 16 amp, slow fuse level
surface (L x W) 50cm x 20cm to attach the control unit,
adjacent to the installation, outside the operational
platform area
- Safeguarding to DIN EN 294
- Lighting to DIN 67528, illumination of parking lots
and buildings for parking
- Foundation exactly to size, clean and dry
- Compliance with installation requirements as per quotation
- The measurements are minimum finished dimensions.
- Tolerances to part C (DIN 18330, 18331) should be
considered supplementary.
- Measurements in cm.
Technical alterations reserved. Alterations in the
scope of supply reserved. Version 14/2002
|
